Reinforced tied workers: Hundreds of "reinforced knots" in their bare hands

In Jiuqin Village, Beilun Chaiqiao, the "Ding Dong" sound of the tools collided with steel bars echoed under the scorching sun, and a piece of steel with a height of more than ten meters flashed silver. Several workers wearing a yellow helmet and orange work clothes were particularly eye -catching in those standing reinforced slices. This morning, their task was to prepare a batch of reinforced steel pieces for the pile foundation of the Liuheng Highway Bridge.

The Liuheng Highway Bridge is 29.6 kilometers in length, which are implemented in two phases. Among them, the first phase of the project starts at Meishan. After crossing the Meiyan Waterway, through the Chunxiao Street, the ending point is connected to the Hangzhou -Ninguka high -speed re -road and the mountain Shuanggang Expressway. , Two -way six lanes.

This is the project from the Kuntingling Tunnel to the Chaiqiao hub during the first phase of the bridge project. This project has both tunnels and hub construction. It is one of the key nodes of the entire bridge. At present, the construction of the project pile foundation is fully launched. In order to accelerate the process standardization process, the project department from Ningbo handed over the work department used prefabricated steel bars, early mixing and concrete to transport the prefabricated steel slices to the construction site and concrete.

Li Hui is one of the reinforced bars. The tie of the reinforcement sheet looks simple but a detailed work, and it is almost bare -handed throughout the process. The only tool is a small reinforced hook. Workers need to put reinforced bars into mesh -shaped, and at the same time, they are tied at the intersection of each steel bars. One morning, everyone must make hundreds of "steel wire knots". These reinforced steel slices made of handmade are then made into beams with concrete and made into important components of roads and bridges with concrete.

The work of steel bars must be completed outdoors. Smillet, the first feeling of this job. Although it is outdoors, because of the work site, a thick helmet is an essential equipment. In the scorching sun, for sunscreen, long -sleeved coats are necessary, and another protective artifact is thick gloves.

"Now there are more than 30 degrees Celsius outdoors, but the temperature of the reinforcement has been 50 or 60 degrees Celsius. If you don't wear gloves, your fingers can not stay on the reinforcement for a few seconds." Li Hui said, but despite wearing gloves, it has to be wet a day. Several times, sometimes the skin of the fingers is soaked. At the moment Li Hui took off his gloves, a hot gas followed his hands.

Fortunately, the project department has also adjusted the work and rest, and the high temperature day has a long lunch break. At this time, Li Huihui and the workers made a small cricket, and by the way to dry the wet jacket soaked by the sweat, and changed to a clean glove.

"My hometown is in Liaoning. I came to Ningbo last November. I did not expect that I encountered continuous high temperature in the first summer." Li Hui said with a smile, but also used to work in Guangdong, Jiangxi and other places. The weather has long been mentally prepared. "There are some summer shelters in the construction site, and they have to protect themselves." Li Hui prepared a large kettle, and he also had Huoxiang Zhengqi water. He had to drink at least three or four pots of water a day. Essence Li Hui said that his wife and children were in the old home, and he went home to see if he was busy.

At high temperatures, the front -line bundling workers like Li Hui were named after the construction site. Their sweat was integrated into the reinforced bars and built a large road bridge for the city.

- END -