Raising and fleshy, the most practical method of watering, "watering the pot", the folds of the leaf folds and then watering

Raising and fleshy, the most practical method of watering, "watering the pot", the folds of the leaf folds and then watering

Raising meat, watering is indispensable. Reasonable watering methods can make succulent grow more safely. Inappropriate watering methods can only cause most of the deaths. As a result of improper watering, excessive watering or high -frequency watering causes fleshy death. Watering is too much, and the flesh must be dead.

So how should I water the fleshy meat? How to water?

The specific watering method is obtained from daily maintenance. The way others teach you may not be applicable for yourself, because everyone raising the fleshy flower and soil ratio is different, plus the local area The temperature is also different. The temperature will affect the evaporation of water vapor. In areas with higher temperatures, the water evaporation speed is fast, and the time interval of watering will be slightly shorter. The experience still needs to be summarized by itself.

If you do n’t have a good way to water the succulent water, you can use the simplest watering method, “watering the pot”, you can observe whether the water is required through the state of the meat blades. Fold will appear. From the perspective of appearance, the leaves will be relatively wrapped, and there is no state of fat in the past. This situation is that the succulent is short of water.

When the succulent leaves have severe folds, the tap water is covered with a basin, put the whole pot of succulent in the washbasin, so that the tap water is not passed through the flower pot, soaked in the water pot in the water, soak it for five minutes, so that the tap water is completely completely water. The method of soaking the flower soil and watering the pot is the most practical. The water is completely immersed in the flower soil, which can allow the fleshy to absorb enough water, and the fold leaves will soon recover.

The simplest method of watering can make the succulent avoid black rot water as much as possible, especially in summer, it is very practical. The temperature in summer is already very high. Watering in the pot, succulent can absorb enough water at one time, wait until the leaves fold next time, and then water it again.

When I first started to raise flesh, I always kept the flesh to death because of watering, and always watered the succulent meat at home from time to time. I inadvertently followed the root system. Later, my friends told me that the watering of the pot was very practical, slow, slow, slow, slow, slow, slow, and slow, slow, slow, slow, slow, slow, slow, and slow, slow, slow, and slow, slow, slow, and slow. With a certain maintenance experience, watering becomes very simple. Watering in the pot can only be used for this method without watering in the early stage.

For example, it is appropriate to use the family to raise succulents, the northern region is basically poured once every 20 days. The fleshy outdoor is determined according to the specific situation. After all, the fleshy outdoor succulent may be dried to the rain. Pour.

The specific watering method should be determined according to the specific situation. There is no accurate time and no accurate amount of watering.

- END -